|Working capacity||1500m2 ± 20%|
|SmartRobby movement speed||to 25m/min|
|Cutting system||2 knife blades|
|Cutting height||3cm / 4cm|
|Cutting width||28cm (14cm/pc)|
|Blades cutting speed||4000rpm ±10%|
|Mowing on slopes||30 degree|
|Average working time||2.5h|
|Average charging time||3h|
|SmartRobby size||56cm x 51cm x 25cm|
|Charging station size||45cm x 38.5cm x 20cm|
|Mowing mode||Straight / Spiral|
|Virtual wire max lenght||300m x 0.75mm|
|Virtual wire in set||100m x 0.5mm|
|Mowing zones (3)||●|
|Mowing mode - straight||●|
|Intelligent lawn recognition||●|
|Bump sensor||● Front|
|Protected against signal loss||●|
|Lift up sensor||●|
SmartRobby Classic is perfectly suited for the lawns of approximately up to 1500m2 in size
With SmartRobby, the lawn always looks as if it was just cut. It can mow as often as needed to keep the lawn looking beautiful. No more worries about making time to mow the lawn or scheduling a lawn service visit before that special event.
SmartRobby Classic is equipped with such functions:
There are lift sensors located on the front wheels. If the mower is lifted from ground, it will stops working within 1 second.
There are tilt sensor installed on the mower too, when the mower is tilted over 30 degrees in any direction, it stops working within 2 seconds.
There are bump sensor equipped at the front of mower, they will activate when the mower strikes solid, fixed, object when that object is at least 6cm in vertical height from the supporting surface of the mower. When the bump sensor activated, the mower will stop movement in that direction and reveres itself away from the obstacle.
There are two rain sensor located on the top cover for SmartRobby Classic. The mower will go back to the charging station automatically when it's raining.
Auto recharge system
when the mower senses a low battery situation, it will shut off the cutting motors and search for virtual wire. Once found it will follow the virtual wire to the charging station for recharge automatically. Once charging is complete, the mower will back up a few centimeters ready to again in stand by mode
Emergency stop switch
There is an emergency switch located on the top of mower and red in color, when pressed, the mower will shut down immediately. Rotate the switch clockwise to release it.
Each of the cutting motors the two running motors are monitored continuously during operation for any situation that may cause these motors to over-load in the event this is detected, the mower stops operating.
Set up one week (From Monday to Sunny, Once for each day) Cutting schedule from the control panel
This function can separate a big lawn into 3 small cutting areas, so it can save more time to cut a big lawn.
2.Virtual wire (100m)
4.virtual wire connectors(10pcs)
7.Remote control battery
8.Inner hexagon spanner